Keywords:Beauty Packaging Manufacturer in China,Skin Care Plastic Tube Suppliers,Cosmetic Tubes Packaging,Cosmetic Squeeze Tubes
Current location: Home»Auber News Center » News Center » Auber News » Printing seam line on cosmetic tube

Printing seam line on cosmetic tube

Categories: Auber NewsStars: 3Stars Visit: - Release time: 2017-10-11 18:00:00
Font size:【 Large Middle Small Source: Editor: Author: Tinna

semi-transparent cosmetic hand tube

Have you ever considered to print a color block or graphic around cosmetic tube when make designing? Over 13 years’ experience in cosmetic packaging, Auber sees many clients like this design. The printing effects really look very nice, but it has a little defect -printing seam line and hard to avoid. Below are different printing seam lines on PE extruding tube and some improvements.

1) Print a circle of color block on PE extruding tube. There will be a 1.5 mm width overlapping joint line, see below pic. This effect looks not bad and many clients think they are fine. How do you like it?
 
Seal line on extruding PE tube
 
2) Print graphic around extruding PE cosmetic tube, see below pic. In this case, the 1.5 mm overlapping part of seam line looks like dislocation. This is hard to improve. Usually we do not advice customer to design like this.
 
PE squeeze tube
 
Based on above two situations, if customers don't like the overlapping or dislocation, it's a good way to choose PBL or ABL tube. The overlapping and graphic of seam line can be matched very well, see below pics; just it has a welding line.
 
overlapping on hand cream tube